0xbt

Causes are more complicated, such as raw material defects (bubble shrinkage holes), forging defects (overheating), heat treatment defects (overheating), processing defects (local burn or surface micro-cracking), mainfractive defect (installation, poor installation, lubrication, lubrication, transient Overload), etc. Invasion of foreign foreign matter is a common pattern that causes the fracture failure of # the holder.

The cage breakage of the holder is broken in an unpretty failure mode. Both overloaded impact load or severe vibrations may make the ferrule break. Capture material defects (such as cracks, large blocks, bubbles, bubbles) and riveted defects (lack, matt or two semi-retaining surface voids, severe riveting), etc. Capture abnormal loads are not installed, tilt, excessive contravement is too large, etc.

The end of the bolt has a thread and a bolt with a tank or a hexagon hole. It is our solution to this application with special bearing steel to make outer walls.Support another special product of the roller application Hongyuan. It is a complete unit of a machine-processed bolt, thrust gasket, an outer ring with a roller pin and a holder assembly or a Wholesale roller bearing factory full unit that is fully installed.

Thick-walled outer ring with a convex surface can withstand the high-diageled force using DIN51825-KP2N-25, the lithium-basal composite soap lubrication specified by DIN51825-KP2N-25 can be used to prevent contamination and water from invading the lip seal gap seal maze seal for the following reasons easy to install. During this movement, the circumference of the support roller has a very sharp force change, the force increases to larger in the shortest time, and the bearing is poorly impacted.

Optimized bearing outer ring contour design, means that the positional tilt can be timely compensated, and the contact stress between the raceways is reduced, which means that the life of the bearing and its peripheral structure is improved. Both the roller drive and the sizinator in the loom are used to support the roller support roller to convert the rotation of the cam disc and the eccentric disc to an accurate set round trip